To properly apply wood grain paper, the first step is to clean the contact surface between the paper and furniture, ensuring no burrs or oil stains. Use sandpaper to polish it smooth, and if necessary, fill the holes with putty.

　　Handmade veneers mainly use white latex or universal glue, evenly apply the glue to the surface of the board, wait for a moment after gluing (the time may vary depending on the environment, which depends on daily practice experience. Generally, when the glue is sticky and not too dry, the bonding force is relatively strong), use a cylinder to roll the paper evenly, gently place it on one end of the sticky paper, and press the edge towards the other end after sticking it firmly. Be careful not to let bubbles enter, then use a knife to scrape off the glue squeezed out of the board edge, and wait for the glue to dry completely.

　　1、 Substrate adjustment

　　1. The substrate must be ground smoothly and finely, and thoroughly touched and inserted. If there is oil dirt, it should be cleaned with a solvent.

　　2. The temperature range for homework is 15 ° C to 20 ° C, and in principle, construction can be carried out at 5 ° C.

　　2、 Flat construction

　　1. Substrate treatment: as described above.

　　2. Position determination: The first position to be placed is fixed with leftover materials.

　　3. Paste: First, tear off the release paper by about 10 centimeters, then use a soft cutting blade to gently press down from top to bottom in order to push out the air.

　　4. If there are small bubbles, you can use a knife tip to puncture and then use a cutting blade to push out the air. It is best to wrap the cutting blade with a soft and damp cloth to avoid damaging the surface.

　　3、 Right angle construction

　　1. Please apply primer to the substrate, dry it thoroughly, and grind it smooth.

　　2. When the flat part is constructed to the right angle part as described above. Gently press in the order shown in the diagram, or use an electric hair dryer to heat and press the construction in sequence. At this time, you can wear gloves or use a soft cloth to lightly press with your fingers to achieve good results.

　　4、 Double right angle construction

　　1. The substrate treatment is the same as described above.

　　2. Paste: First, paste A and fold it onto the B side, then fold the B side onto the quilt surface, and cut off the excess film. (Note: If the dot printing part of A and B overlaps, it will protrude here. For aesthetic reasons, it is not necessary to fold A onto B).

　　5、 Construction method for cubic surface section

　　1. The corners of the substrate should be thoroughly coated with primer (3-4 times), and after drying, ground with # 400 sandpaper until smooth and compliant.

　　2. Paste: Use an electric hair dryer to fully heat the corners and wait for the Boli film to have appropriate softness. Pull down the upper end in order B ` C ` D ` E ` and press it down.

　　3. Please note: Slowly pull from the top in the order of A ` B ` C ` D ` E ` (less than one centimeter each time), press with your fingers and move to B ` C ` D ` E `, then repeat from A to the bottom. Do not be impatient and pull all at once to the bottom, as it may cause wrinkles that are difficult to handle.

　　4. When heating and pulling down, it is advisable to extend your fingers deep inside (do not only pull towards the edges, pull while pressing to achieve good construction results).